|
Size: 218
Comment:
|
← Revision 7 as of 2012-06-23 13:42:42 ⇥
Size: 1161
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 3: | Line 3: |
| This page contains information about the Technical Workpackage ''Satellite Base Infrastracture'', the other workpackages can be found at: <<Navigation(siblings, 1)>> |
This page contains information about the Technical Workpackage ''Satellite Base Infrastracture'' <<Navigation(siblings, 1)>> '''Leader:''' ''Christian Pointner'' <<MailTo(equinox AT mur DOT at)>> == Base Electronics == [[attachment:satellite-bus-rev4.pdf|Current Schemtic of the satellite bus]] === Power === ==== Power Management System Sketch ==== {{attachment:tafel_schaltplan_energiesystem.png|Sketch of power mmanagement syste|width=800}} ==== Solar Soldering ==== Soldering the solar panels on the PCB's was one of the great challanges. At least i thougt it would be very tricky, but it turned out that it is actually quite easy. For the purpose we bought the reflow kit together with the controller from [[http://www.reflow-kit.com/|www.reflow-kit.com]]. The equipment was very useful and made soldering the panels very easy. It will also be very useful for the other PCB's and is for sure a very good investment. The results can be seen on the following picture. showing the first of our solar panel boards: {{attachment:solar-soldering.jpg|Solar Panel Soldering|width=480}} |
Workpackage: Satellite Base Infrastracture
This page contains information about the Technical Workpackage Satellite Base Infrastracture
| /Balloon /CommunicationProto /CommunicationRadio /SatelliteApplications /SatelliteBaseInfrastracture /TestEnvironment |
Leader: Christian Pointner <equinox AT mur DOT at>
Base Electronics
Current Schemtic of the satellite bus
Power
Power Management System Sketch
Solar Soldering
Soldering the solar panels on the PCB's was one of the great challanges. At least i thougt it would be very tricky, but it turned out that it is actually quite easy. For the purpose we bought the reflow kit together with the controller from www.reflow-kit.com. The equipment was very useful and made soldering the panels very easy. It will also be very useful for the other PCB's and is for sure a very good investment. The results can be seen on the following picture. showing the first of our solar panel boards:
